Citroen Specials Club - the club for all lightweight cyclecars

Just a word of warning.

The anti-roll bar is made from tempered spring steel.

The heat from welding would destroy the temper.

Hi, One thought to bear in mind is that as the car was built by Lomax, as was my first 223, it was not built from a single donor but from a stock of parts built up over quite a few years. The L.H. spring set will have been taken off a rack of spring sets and similarly the R.H. set. The carb. might n...

Hi,

For taps and dies of all sizes and pitches try Wiseman of Redditch

Tel. 01527 520580

Good luck.

John

If my maths is right! The standard front ride height for a 2CV is 195mm. and the caster angle is 15degrees. For every 5mm. by which you lower the ride height from this standard you would need to correct the caster angle by 3/4degree to maintain the 15degree caster angle. If you go too far with reduc...

Hi,

On my 223, I have set the ride height at 180mm. front and back.

This is with full normal load.

This is also with coupled rear suspension.

The ride and handling are good at this setting.

Good luck and enjoy the fleeting sunshine.

John