Citroen Specials Club - the club for all lightweight cyclecars

If you are interested I obtained a pair of mg seat framed from Rugby Classic Motor Garage in Warwickshire at a very reasonable price. tel 01788571896 www.rugbyclassics.com I reupholstered the useing a kit fro Mirror Trim at Toddington Bedfordshire. tel 01525874858 www.mirrortrim.co.uk They made the ...

Thanks for this, can you confirm that the left to right is looking at the pins from the bottom of the regulator and not the end of the plug

Can any one help with the wiring of a regulator.
The terminals on the regulator are not marked and the wiring harness plug only has three grey wires none of which are colour coded.

I am about toi fit one to a Lambda.
Have you any photos of your setup of the GS floor change,
Please can you email jb.griffiths@outlook.com. with any information.
Thanks

Having used the 9mm method with no success i tried this method useing a 3/8 bsf bolt fully threaded. I put a nut on, up to the nut head and then a large washer, this I screwed in to the tapped hole through a socket and then undid the nut and holding the bolt, This made a brilliand puller and the tub...

Thanks for the information that will be a great help.
It looks as though the trailer should be ok.

I have been offered a trailer but before I accept it I would like to confirm the front wheel base of a Lambda.
I am unable to get to my car that I am building until the end of the month. Would be a shame to miss this.

Many thanks for help. If any one is looking for a M9/125 bolt I obtained one 43mm long from the local engineering company that overhauls and rebuilds engines. The one he gave me is the con rod bolt from a late Rover 75 that used the BMW Engine. He also had lent me a tap to cut the thread on the unde...

Thnaks for the advice. I will give it a go this weekend. Hope i dont have to go down the road of tappint it out.

Having just rebuilt the engine from a box of parts I have now found to my horror that the dipstick tube is blocked.
I do not really want to dismantle the engine again, can any one help and tell me how to remove the tube to clear it.