Suspension seems hard

Discuss all things technical

Moderator: moderator

Post Reply
Venture
Posts: 56
Joined: Tue Mar 17, 2015 8:27 pm
CSC Membership Number: 2064j
Country: UK
Region: North wales

Suspension seems hard

Post by Venture » Fri Aug 04, 2017 7:08 pm

Hi on passenger side suspension seem to be lower than other side,and seems to go hard when on rough or ruts in road and makes the steering shake.I feel it might need new suspension cans would this be the problem.If so does anyone have spare ones to sell cheers from

david
Posts: 124
Joined: Fri Aug 24, 2012 11:45 am
Country: france
Region: lot

Re: Suspension seems hard

Post by david » Wed Aug 16, 2017 10:50 am

presume you squirt caster oil inside the cylinders regularly to keep them sliding???

Venture
Posts: 56
Joined: Tue Mar 17, 2015 8:27 pm
CSC Membership Number: 2064j
Country: UK
Region: North wales

Re: Suspension seems hard

Post by Venture » Wed Aug 16, 2017 9:04 pm

That a new one to me enlighten many thanks

llanigraham
Posts: 214
Joined: Sat Dec 12, 2015 8:18 pm
CSC Membership Number: 2093
Country: Wales
Region: Powys
Location: Llanidloes

Re: Suspension seems hard

Post by llanigraham » Wed Aug 16, 2017 11:52 pm

Ditto!
1972 MG Midget
MSA Radio: Worcester 1

User avatar
billdavies
Posts: 79
Joined: Mon Aug 20, 2012 9:18 am
CSC Membership Number: 1986
Country: UK
Region: Ayrshire KA7
Location: Ayrshire

Re: Suspension seems hard

Post by billdavies » Thu Aug 17, 2017 9:17 pm

Hi,
To stop squeaking and shuddering etc of the springs inside the suspension cans they require to be lubricated, like all things that slide in contact.
In the case of the spring cans use a oil can filled with Castor oil and give them a squirt every thousand miles...since you've not done it to date would recommend a liberal dosage to each can...say ten squirts, then take the beastie out for a spin on a bumpy road to displace the oil around the inside of the can. This may need to be repeated to obtain a smooth operation/action.
regards Bill
Own design and build of trike,2CV powered and transmission

Colin-gser
Posts: 10
Joined: Sat Sep 29, 2012 7:43 am
CSC Membership Number: 1821
Country: UK
Region: East Sussex

Re: Suspension seems hard

Post by Colin-gser » Wed Nov 01, 2017 7:53 pm

Hi

Inside the can are large diameter springs, the end fitting having what is effectively a brake shoe type material around it’s outside surface with a clearance fit to the tube

The oil lubricates this but if the rubber seals at each end of the tube have also perished water may have entered and rusted the surface, this and lack of regular oiling may be the problem, but I’d also unscrew tie rods and check knife edges and swing arm bearings for smooth operation and action of dampers

Colin

Post Reply